3D Printed TPU Landing Gear for 5 inch FrameDescriptions:This TPU skid plate attaches to your velcro strap giving you a solid base to land on when flying a quad that straps the flight pack to the bott..
Feature:Material:3D PrintingColor:red/purpleDesign for Foxeer lollipopKindly Note:Standoff outside diameter:6mmMust have 2pcs standoffSuit for 10-36mm wideth Frame.So before ordering,pls check whether..
This TPU print is made for the XL series, HL series, iH3 and TAU series frame or any frame with close to 26-30mm width standoffs.It holds your SMA/AXii connector and RX antenna tubes at an upward angl..
Feature:Material:3D PrintingFunction:protect the plug from the dust when do not use so that can extend the libo battery life.For XT60/XT90 Female/male plug connectorPackage included:10pcs protect case..
For Archer X5Material: 3D Printed TPUWorking with the top board, it can make the drone fly again (propellers still work) when the drone is turned over on the groundTotal height: 45mmFixing way: screws..